The Acksys AirWan is an industrial dual band Wi-Fi access point with LTE modem.
¶ Specifications
| Interface | 1 Ethernet port 1 Ethernet port with PoE 802.3af 3-pin Phoenix connector for power supply 2 RP-SMA male WiFi antenna ports 2 SMA female LTE antenna ports 1 SMA female GNSS antenna port Reset button SIM card slot |
| CPU | Qualcomm Atheros QCA9558 SoC |
| Memory / Storage | 128MB DDR2 / 128MB NAND Flash |
| Wi-Fi | 802.11a/b/g/n |
| LEDs | Power Status Wifi Status Cellular Status |
| Power Input | +9 VDC to +48 VDC |
| Operating Temperature | -20°C to +60°C |
| Dimensions / Weight | 147mm x 100mm x 41mm, 382g |
| Certifications | Shock and vibration: EN 61373 Fire/smoke: UNR118, RoHS, WEEE |
| Downloads | Data sheet MeshmerizeOS Factory Image MeshmerizeOS Upgrade Image |
¶ Installation
MeshmerizeOS can be directly installed through the Acksys WaveOS web UI or with WaveManager.
- Download the MeshmerizeOS Factory Image from the link above.
- Follow the instructions in the Acksys user guide for initially connecting to the device.
- In the web UI, go to Tools > Firmware Upgrade.
- Select the MeshmerizeOS Factory Image and continue with “Upload”
- On the next page, confirm the upgrade with the button “Upgrade now”
During the upgrade, the Power/Diag LED will flash red. Do not remove power from the device during the upgrade. The upgrade is complete when the LED changes to green.
¶ Reset
The device can be rebooted with the reset button next to the power supply. A short press of the reset button will trigger a reboot.
Holding the button for at least 5 seconds will trigger a firmware reset. This will revert all configuration changes and bring the device back to the fresh state after installing MeshmerizeOS. The firmware reset can only be triggered while the device is properly booted, indicated by the green Power/Diag LED.