Industrial IoT Access Point
Rugged Dual-Band 2x2, 802.11ac Wave 2 WiFi
¶ Specifications
| Interface | Ethernet: 1 GbE (PoE, 802.3at Type 1 Class 3): -13 W Console: Mini-USB Antenna ports: 2x2,4GHz, 2x5GHz, 1xBluetooth Reset button |
| CPU | QCA IPQ4029 Quad-core ARM CPU (Cortex-A7 + NEON + FPU) |
| Memory / Storage | DDR3LP 1GB (16-Bit) NOR Boot Flash (4MB) NAND Flash (256 MB) |
| Wi-Fi | 2.4 GHz: 802.11b/g/n, 2x2:2 5 GHz: 802.11a/n/ac Wave 2, 2x2:2 |
| Operating Temperature | -40°C to +65°C -40°C to +55°C with Full Sun Load |
| Dimensions / Weight | 7.84" x 5.79" x 2.50" (199 x 148 x 64 mm) |
| Certifications | IP67 Compliance: FCC, ISED, ETSI |
| Downloads | datasheet MeshmerizeOs factory image MeshmerizeOS sysupgrade image |
¶ Installation
¶
Sysupgrade From QSDK to MeshmerizeOS
This section is only necessary when flashing a device with MeshmerizeOS for the first time.
- Connect to the serial console. Interrupt autobooting by pressing Enter when prompted.
- Copy the factory image from above to your tftp server
- Run the following commands from your u-boot terminal:
- Tftpboot factory.ubi
- nand device 0
- nand erase.chip; nand write ${fileaddr} 0x0 ${filesize}
4. Configure the bootcmd for OpenWRT:
- setenv nandboot_openwrt "bootipq; bootm 0x84000000"
- setenv bootcmd "run nandboot_openwrt"
- saveenv
5. From the u-boot terminal run: run bootcmd
¶ Sysupgrade MeshmerizeOS.
When upgrading MeshmerizeOS itself, use this section.
¶ Via ssh
Copy the sysupgrade image from above to the target device via scp then run the sysupgrade command followed by the filepath.
¶ Via webui
Go to:
- Webui: 192.168.1.1
- System → Backup/Flash firmware→ Flash new firmware image
- Upload the new firmware and click upload.